master window switch. Asked by tennisbumj May 16, 2012 at 09:49 AM about the 2009 Dodge Journey. Question type: Maintenance & Repair. master window switch will not work the front windows or the power mirrors but will work the rear windows.Replace the switch but didnt help. any suggestions on the wiring harness. 255 posts · Joined 2022. #13 · May 29, 2022. The story continues on the Miscreant Window. Sprayed WD-40 on master switch rear window button, although good advice not to because of warranty, held down button while slapping rear window, slammed (not that hard) rear door 25 times, sprayed WD-40 in window tracks. In this guide, I will demonstrate how to fix a faulty power window switch on a 2005 Nissan Frontier (King Cab). I did this after the driver-side switch for controlling the passenger window did not work. After further inspection of the switch circuit board, I noticed that the electrical contacts were dirty.
This is why I suspect you have two problems, since the window doesn't work from either switch. If you look at diagram number three, the first one below, everything following my red line has to be good because the rear windows work. That includes the master lock-out switch in the driver's door switch assembly, up to the splice # S314.
Disconnected driver mirror motor and found that lin bus was not working properly and that switch block would move mirrors and windows correctly. Replaced mirror motor and checked operation. Repl dr mirror motor. 1 67-13-6-965-061 rep kit f memory drive: 671010". Hope this helps.
If that is okay, you want to check the switch. " (1) Remove the desired switch to be tested from the door trim panel. Driver’s side (master) or passenger side. (2) Using an ohmmeter, Test driver door switch for. continuity. If you do need a new window motor, or regulator, check these instructions out. WINDOW REGULATOR - POWER REMOVAL. if i hold the power window down switch for more than few seconds the switch "MIGHT" start working, this is inconsistent also. If i open the drivers door while the switch is not working in about 20-25 seconds the switch "MIGHT" start working. I can see the illuminated red glow just fine and everytime.

Remove the power window switch panel (A). à † -1 Insert a flat-tip screwdriver wrapped with protective tape through the hole under the armrest, and push up the bottom of the power window switch (B) to release the panel. à † -2 Pull out along the edge of the panel to release the hook (C) and clips (D).

ocqi64.
  • 27v67zipwo.pages.dev/13
  • 27v67zipwo.pages.dev/342
  • 27v67zipwo.pages.dev/112
  • 27v67zipwo.pages.dev/253
  • 27v67zipwo.pages.dev/344
  • 27v67zipwo.pages.dev/483
  • 27v67zipwo.pages.dev/31
  • 27v67zipwo.pages.dev/128

    • power window switch problem