Question: 1 A washing machine starts when a coin is deposited. It then sequences through the following stages: soak, wash, rinse, and spin. There is a "double wash" switch, which, if turned on, causes a second wash and rinse to occur. There is one timer only-soak, wash, rinse, and spin take a fixed amount of times t1, t2, t3, and t4
At a Glance. The uE/UE/Ub code indicates that the washer is attempting to balance the load, which may be the result of the unit not being leveled correctly or the load itself. This code can be easily resolved without the need of a technician. When the uE/UE displays on the screen, the unit will fill with water in order to agitate and separate
The rinse and spin cycle on a washing machine essentially skips the pre-wash and just rinses the clothes with water before spin drying them. This means there will be no detergent used, so the clothes are not washed - only rinsed with fresh water before being spun. When to Use Rinse and Spin?
Centennial washer should coast to a stop for 30 to 45 seconds ="wash" + "rinse" + "done" + "lock". Centennial washer lid lock should unlock in 1 second and not longer than 3 minutes="wash" + "rinse" + "spin". Free Maytag Centennial Washer Diagnostic Guide. Automatic Diagnostics For Your Maytag Centennial Washing Machine.
Add detergent: Pour laundry detergent into the appropriate compartment. Start the wash cycle: Begin the wash cycle. The machine will fill with water, agitate the clothes with detergent, and then drain the dirty, soapy water. Rinse cycle: The machine will refill with clean water and "rewash" your clothes to remove any remaining detergent and PLJZHL.